LANCER TACTICAL Limited Edition LT-29 Proline GEN2 Enforcer Needletail Gold

Full metal, mosfet, ETU, lightened Skeleton body for speed

The most important evolution of the new generation 2 Proline is undoubtedly the original addition of an ETU electronic trigger and a protection mosfet. This trigger allows increased responsiveness, finer trigger travel sensitivity, battery voltage protection, collet gearbox cycles, spring pre-compression for a much faster start of fire, etc... small revolution, always at an affordable price.   Gearbox:

• Lancer Tactcial Engraved Metal Gearbox Shells
• 18:1 ratio steel gears
• delay
• 8mm bearings
• 14 tooth steel piston
• Red anodized cylinder for improved surface finish
• Hi-speed motor with Neodyn magnets 25000rpm
• QD steel spring guide on bearings
• Spring M120
• Quick spring change (QD)
• Shielded low resistance wiring
• Hi-speed type metal trigger
• "Fast trigger" electronic trigger block with increased responsiveness and higher rate of fire
• 16AWG shielded wiring (rear)
• Protective Mosfet in the stock tube (battery protection)

Internal parts:

• 6.03mm precision polished brass barrel
• Center wheel hop-up block (Gen 2)
• 50° hop-up joint

External parts:

• Skeleton type aluminum body (lightened for speed soft)
• Metal outer barrel
• Folding Nylon fiber sight
• Ergonomic metal saddle
• Aluminum M-LOK handguard
• Single point steel strap attachment
• Alpha nylon fiber stock with additional magazine slot
• Metal stock tube
• Steel dummy cylinder head
• Steel cocking lever with hi-speed handle
• Steel magazine catch
• Bolt catch (fictional) in metal
• 120-round metal mid-cap magazine
• Semi and full auto