English 
Nederlands 
Full metal, mosfet, ETU, aluminum body and handguard
The most important evolution of the new generation 2 Proline is undoubtedly the original addition of an ETU electronic trigger and a protection mosfet. This trigger allows increased responsiveness, finer trigger travel sensitivity, battery voltage protection, collet gearbox cycles, spring pre-compression for a much faster start of fire, etc… small revolution, always at an affordable price.
Gearbox:
- Lancer Tactcial Engraved Metal Gearbox Shells
- 18:1 ratio steel gears
- delay
- 8mm bearings
- 14 tooth steel piston
- Red anodized cylinder for improved surface finish
- Hi-speed motor with Neodyn magnets 25000rpm
- QD steel spring guide on bearings
- Spring M90
- Quick spring change (QD)
- Shielded low resistance wiring
- Hi-speed type metal trigger
- “Fast trigger” electronic trigger block with increased responsiveness and higher rate of fire
- 16AWG shielded wiring (rear)
- Protective Mosfet in the stock tube (battery protection)
Internal parts:
- 6.03mm precision polished brass barrel
- Center wheel hop-up block (Gen 2)
- 50° hop-up joint
External parts:
- Aluminum body
- Metal outer barrel
- Folding Nylon fiber sight
- Ergonomic metal saddle
- Aluminum M-LOK handguard
- Single point steel strap attachment
- Polymer crane stock (allows to insert double and triple stick batteries)
- cnc aluminum stock tube
- Steel dummy cylinder head
- Steel cocking lever with hi-speed handle
- Steel magazine catch
- Bolt catch (fictional) in metal
- 120-round metal mid-cap magazine
- Semi and full auto
- Flash hider with 14mm CCW screw pitch (anti-hotary)
- Battery and battery charger not included
